Linear Gate Motor & Opener Nationwide

Linear Gate Motor & Opener in Grapevine: What to Know First

Linear gate motor and opener repair in Grapevine typically runs $185 to $520, depending on whether the problem is a capacitor, a control board, or the motor itself, and most jobs are completed the same day we arrive. We service every Linear line still common in this area, including the APeX, MegaCode, and older swing-arm models, and we quote the full price before any work begins. If your Linear opener is dead, grinding, or opening halfway and reversing, call us at (432) 237-4128 and a live person will answer, any hour, any day.

Call (432) 237-4128

This page is for Grapevine homeowners who own a Linear gate opener and want to know what is actually wrong with it, what it should cost to fix, and whether it is worth repairing or replacing. We are an independent Linear service provider, not a factory authorized dealer, which means we answer to you and the gate in front of us, not to a corporate warranty department.

How Linear Products Fail - and How We Fix Them

Linear built a reputation for simple, durable openers, and many Grapevine homes still run them a decade or more after installation. But two or three failure modes account for most of the Linear calls we take, and they are predictable once you know the equipment.

• APeX control board relay failure. The APeX series uses an onboard relay to trigger the motor, and after repeated cycles in Texas heat, that relay welds or develops pitted contacts. The gate will hum but not move, or open but refuse to close. The factory fix replaces the entire board at several hundred dollars. We often replace just the relay when the board is otherwise sound, a repair that takes under an hour and costs a fraction of a new control board. We only do this when it is the correct fix, and we tell you before we do it.
• MegaCode receiver drift and remote lockout. Linear MegaCode systems rotate codes to prevent signal grabbing, but the receiver can drift out of sync after power surges, which are common on the Grapevine side of the lake during storm season. Homeowners describe it as remotes working one day and not the next. The fix is usually a receiver reset and re-learn, not a new opener. We also check for a dying 9-volt in the transmitter, which causes the same symptom and costs two dollars.
• Capacitor failure on older Linear swing-arm models. A weak or failed capacitor is the single most common reason a 10-plus-year-old Linear opener struggles to start, moves slowly, or trips its breaker. On an AC swing-arm motor, the capacitor gives the motor its starting torque. Grapevine’s heat shortens capacitor life, and the fix is a straightforward replacement that restores normal operation rather than replacing a motor that still has years left.
• Limit switch misadjustment on Linear slide motors. Linear slide openers use mechanical limit switches to tell the motor where to stop. When those cams drift out of position, the gate over-travels and rams the post, or stops short and leaves a gap. We set limits back to the correct travel, then run the gate through ten open-close cycles to confirm it settles in the same place every time. That is the only way to set a limit correctly, and we do not skip the test.
• Gear wear from a gate that was never serviced. A Linear opener is only as healthy as the gate it moves. When we see stripped gears or a smoked motor on a Linear unit, the cause is almost always a gate that had been dragging for a year or more. The opener was doing work it was never sized for. We fix the opener and correct the gate, because installing a new motor on a bad gate just means ordering another motor next season.

Our Linear Gate Motor & Opener Process

When you call about a Linear opener that is not working, here is exactly what happens, from the phone call to the driveway.

1. 1
   You talk to a person, not a queue. Call (432) 237-4128 and one of our own people answers, day or night. We get your address, the symptom, and the brand and model if you know it. Then we set a time and we show up when we say we will.
2. 2
   Diagnosis before parts. Our technician checks the power supply, the capacitor, the control board, the limit settings, and the gate itself. We determine the cause before we touch anything else, and we tell you what we found.
3. 3
   A firm price before work starts. We quote the repair price and the part cost, and we ask for your approval before a single part is ordered or a single bolt is turned. If you decide not to proceed, you owe only the diagnostic fee, which we tell you about on the phone.
4. 4
   The repair, done once. We use OEM Linear parts where it matters for safety or warranty, and we use quality aftermarket parts where they are mechanically identical and meaningfully cheaper. We tell you which is which and why.
5. 5
   We test, then we show you. After the repair we cycle the gate repeatedly, demonstrate the safety reverse, and walk you through what we fixed. Then we write it up, and every job carries our 90-Day Done Right Promise, in writing.

What Linear Gate Motor & Opener Costs in Grapevine

Pricing on Linear work in this area breaks down into a few common scenarios, and we keep the numbers honest because the bill should never be a surprise.

• Capacitor replacement: $185 to $265, including the part and labor.
• Relay or receiver board repair (non-factory): $240 to $380, depending on the board and access.
• Full OEM control board replacement: $390 to $620, including programming and testing.
• Complete Linear opener replacement, installed: $1,150 to $2,300, depending on the model, gate weight, and whether we reuse existing brackets and wiring.

What moves the price most is whether the failure is a repairable component or a dead board, and whether the gate itself needs alignment or hardware work at the same time. We tell you the number before we start, and it does not change afterward. Call (432) 237-4128 for a free estimate on your specific Linear opener.

Why Grapevine Homeowners Call Ironworks Gate Co. for Linear Work

We have been working on gates in this town for over 42 years, and we got here by doing the unglamorous thing: showing up, diagnosing correctly, and standing behind the work. Every Linear repair we complete carries our 90-Day Done Right Promise in writing, so if the same problem comes back inside ninety days, we return and make it right without paperwork or argument. Our technicians are background-checked and uniformed, and they treat your driveway the way they would treat their own mother’s.

And while Linear is a brand we know well, it is not the only one. We are trained and certified on LiftMaster, Mighty Mule, Ghost Controls, DoorKing, and five other major lines, so when the diagnosis shows the opener is beyond saving and you want a different manufacturer, we can give you a straight comparison and install the right unit the first time.

FAQs